From Sketch to 3D and Back was a two week course about developing and presenting form in both 2D and 3D using various techniques from sketching and foam modeling, to 3D modeling. During the first week we had hands on lessons on the fundamentals of sketching, foam modeling, Illustrator rendering, Photoshop rendering, and 3D software. The second week we were tasked to design a kitchen mixer using the techniques we learned during the previous week, though we did not need to keep the same workflow or structure, and were free to approach this from any angle we wanted. At the end of the week we once again presented our work in an exhibition setup and received feedback on the results.